Gelatin Molded Champagne Bottle
Serves: 2
Estell Schumm
1 January 1970
Based on User reviews:
59
Spice
46
Sweetness
53
Sourness
40
mins
Prep time (avg)
4.8
Difficulty
Ingredients:
Directions:
1
Special equipment: see source link for information: Silkscreen kit Aluminum flashing Champagne bottle For the Bottle Mold: Combine the gelatin and water in the bowl and let bloom
2
Add the sugar and place the bowl over a double boiler
3
Melt until the gelatin and sugar are dissolved and the mixture is smooth and clear
4
Skim the top, if necessary, and discard
5
To make the container in which you will create the gelatin bottle mold, you will need a piece of aluminum flashing that is at least 3 inches longer than the height of the bottle and wide enough to wrap around the bottle 1 1/2 times
6
Curve the flashing, creating a container the bottle can lay in with at least 1-inch of space on all sides
7
Seal the open sides completely with duct tape and tape a wooden spoon or spatula along the top of the flashing on each side to add extra rigidity to the mold
8
The final product should look like the template
9
Pour a 1-inch thick layer of the hot gelatin liquid into the bottom of the mold
10
Place in the refrigerator and allow to set
11
When the gelatin is very firm, remove from the refrigerator
12
Heat the remaining gelatin so it is a liquid consistency if it has started to solidify
13
Place the champagne bottle on top of the firm gelatin
14
Pour the remaining gelatin liquid over the bottle, covering the top by about 1-inch
15
Let this sit until the gelatin begins to gel
16
Move it to the refrigerator and allow to set until the gelatin is very firm
17
When it is firm, remove it from the refrigerator cut the duct tape on the ends and peel away the aluminum flashing so you are left with only the bottle completely encased in gelatin
18
Using a sharp paring knife, slice the mold the long way into two identical halves
19
Remove the champagne bottle
20
For the Chocolate Bottle: Fill one half of the mold with chocolate
21
Place a wire rack so it sits on top of (not inside) a deep roasting pan
22
Overturn the filled mold onto the wire rack
23
The excess chocolate will drain from the mold
24
Allow the chocolate to set slightly
25
This is important because once the chocolate starts to harden, about 5 minutes, scrape the edge clean with a paring knife
26
When the chocolate sets, it shrinks or retracts from the sides of the mold
27
A clean edge will keep it from sticking and cracking as it shrinks
28
You can place the mold in the refrigerator for several minutes to help the chocolate to harden
29
Repeat with the other half of the mold
30
Unmold both chocolate bottle halves by pulling the gelatin away from the chocolate
31
If you are not going to fill the bottle with candies or truffles, use tempered chocolate to glue the two halves together to create the bottle
32
For the Decorated Label: You can either paint the label freehand or use a silk screen kit
33
Either way, start by using a rolling pin to roll the chocolate plastic about 1/8-inch thick
34
If you are going to paint freehand, use a paring knife to cut a square the size of the label you would like to make
35
Mix up your paints by combining the cocoa butter and the powdered food coloring in a 6-to-1 ratio, respectively
36
Add the cocoa butter slowly until you achieve a medium thickness
37
The best way to store and warm your paints while you are using them is in a yogurt machine
38
Use a paintbrush to paint the label
39
If you are using a silk screen kit, start by melting the unsweetened chocolate over a double boiler
40
Hold the silk screen over the rolled out chocolate plastic
41
Using a plastic scraper with a straight edge, apply about a teaspoon of melted chocolate to the silkscreen, and gently pull it across the design
42
Carefully lift off the silk screen
43
It will dry almost immediately
44
Using a paring knife, cut out the label
45
For the Gold Top: Combine the gold dust with the liqueur in a 6-to-1 ratio, respectively
46
Use the gold paint to coat the top of the bottle to represent the gold foil typically found on champagne bottles
47
How to Temper Chocolate(From Dessert Circus, Extraordinary Desserts You Can Make At Home by Jacques Torres): Chocolate is tempered so that after it has been melted, it retains its gloss and hardens again without becoming chalky and white (that happens when the molecules of fat separate and form on top of the chocolate)
48
There are a variety of ways to temper
49
One of the easiest ways to temper chocolate is to chop it into small pieces and then place it in the microwave for 30 seconds at a time on high power until most of the chocolate is melted
50
Be very careful not to overheat it
51
(The temperature of dark chocolate should be between 88 and 90 degrees F, slightly warmer than your bottom lip
52
It will retain its shape even when mostly melted
53
White and milk chocolates melt at a temperature approximately 2 degrees F less because of the amount of lactose they contain
54
) Any remaining lumps will melt in the chocolate's residual heat
55
Use an immersion blender or whisk to break up the lumps
56
Usually, chocolate begins to set, or crystallize, along the side of the bowl
57
As it sets, mix those crystals into the melted chocolate to temper it
58
A glass bowl retains heat well and keeps the chocolate tempered longer
59
Another way to temper chocolate is called seeding
60
In this method, add small pieces of unmelted chocolate to melted chocolate
61
The amount of unmelted chocolate to be added depends on the temperature of the melted chocolate, but is usually 1/4 of the total amount
62
It is easiest to use an immersion blender for this, or a whisk
63
The classic way to temper chocolate is called tabliering
64
Two thirds of the melted chocolate is poured onto a marble or another cold work surface
65
The chocolate is spread out and worked with a spatula until its temperature is approximately 81 degrees F
66
At this stage, it is thick and begins to set
67
This tempered chocolate is then added to the remaining non-tempered chocolate and mixed thoroughly until the mass has a completely uniform temperature
68
If the temperature is still too high, part of the chocolate is worked further on the cold surface until the correct temperature is reached
69
This is a lot of work, requires a lot of room, and makes a big mess
70
A simple method of checking tempering, is to apply a small quantity of chocolate to a piece of paper or to the point of a knife
71
If the chocolate has been correctly tempered, it will harden evenly and show a good gloss within a few minutes