Chocolate Covered Dried Cherries
Serves: 4
Keyon Hand
1 January 1970
Based on User reviews:
47
Spice
54
Sweetness
47
Sourness
37
mins
Prep time (avg)
5.1
Difficulty
Ingredients:
2 cups
Dried CherryDirections:
1
Place the dried cherries in a coating pan attached to a stand mixer
2
Spin at low speed
3
Using a ladle, add the chocolate to the spinning cherries
4
Add one ladleful at a time until the cherries are coated to the desired thickness
5
(Use a 50/50 ratio (50 percent chocolate, 50 percent weight of the cherries
6
) If a thicker coat is desired, use more chocolate and vice versa
7
How to Temper Chocolate(From Dessert Circus, Extraordinary Desserts You Can Make At Home by Jacques Torres): Chocolate is tempered so that after it has been melted, it retains its gloss and hardens again without becoming chalky and white (that happens when the molecules of fat separate and form on top of the chocolate)
8
There are a variety of ways to temper
9
One of the easiest ways to temper chocolate is to chop it into small pieces and then place it in the microwave for 30 seconds at a time on high power until most of the chocolate is melted
10
Be very careful not to overheat it
11
(The temperature of dark chocolate should be between 88 and 90 degrees F, slightly warmer than your bottom lip
12
It will retain its shape even when mostly melted
13
White and milk chocolates melt at a temperature approximately 2 degrees F less because of the amount of lactose they contain
14
) Any remaining lumps will melt in the chocolate's residual heat
15
Use an immersion blender or whisk to break up the lumps
16
Usually, chocolate begins to set, or crystallize, along the side of the bowl
17
As it sets, mix those crystals into the melted chocolate to temper it
18
A glass bowl retains heat well and keeps the chocolate tempered longer
19
Another way to temper chocolate is called seeding
20
In this method, add small pieces of unmelted chocolate to melted chocolate
21
The amount of unmelted chocolate to be added depends on the temperature of the melted chocolate, but is usually 1/4 of the total amount
22
It is easiest to use an immersion blender for this, or a whisk
23
The classic way to temper chocolate is called tabliering
24
Two thirds of the melted chocolate is poured onto a marble or another cold work surface
25
The chocolate is spread out and worked with a spatula until its temperature is approximately 81 degrees F
26
At this stage, it is thick and begins to set
27
This tempered chocolate is then added to the remaining non-tempered chocolate and mixed thoroughly until the mass has a completely uniform temperature
28
If the temperature is still too high, part of the chocolate is worked further on the cold surface until the correct temperature is reached
29
This is a lot of work, requires a lot of room, and makes a big mess
30
A simple method of checking tempering, is to apply a small quantity of chocolate to a piece of paper or to the point of a knife
31
If the chocolate has been correctly tempered, it will harden evenly and show a good gloss within a few minutes